Hebrew  |  English  |  Russian  |  Arabic  |  
דף הבית >> דף הבית >> תפריט תעשיות >> תעשיית נפט >> HEC ניקוי מחליפי חום
                                                                   Green Life Group

                                                                            TECHNICAL DATA SHEET

                                                                           HEC - Heat Exchanger Cleaner
 A powerful non chlorinated degreaser for cleaning heat exchanger systems
HEC Cleaner is a powerful non chlorinated cleaner for the cleaning of metallic surfaces special for heat transfer systems. Does not damage  rubber, plastic, metal or stainless steel surfaces.
HEC Cleaner has been specially formulated to remove oil, grease and general workshop grime from metal surfaces in preparation for HEC dye penetrant and developer application.
This product may also be used as a general workshop degreasing cleaning or where a fast drying solvent cleaner is required.
HEC Is made from renewable raw materials –glucose derived from corn, and fatty alcohols from coconut and palm kernel oils due to its natural chemistry mixt with natural silicates.
This product is very mild, low in toxicity and readily Biodegradable.                                
Summary of Benefits
  • Excellent Cleaning Action
  • Non flammable
  • No solvent smell
  • Free From Chlorinated Solvents
  • Safe On All Metals
          Final stage Clean Up of oil pollution and oil spills  
  • Machinery cleaning
 HEC - Heat Exchanger  Cleaner
A powerful non chlorinated degreaser for cleaning heat exchanger systems


        Appearance:                            -  CLEAR COLOURLESS LIQUID
        pH @ 10% DILUTION                   -           12-13
        Density                                                -           1.06
        Flash Point                             -           None              
        Solubility in water                     -           Immiscible
        Shelf Life                                   -           3 Years from date of manufacture
Directions for use
        HEC is a cold, ready-to-use product. Do not mix or dilute with any other  
  1. Isolate the oil supply, disconnect the heat exchanger oil inlet and outlet, drain off any remaining oil.
  2. Connect the discharge side of Cleaning Unit (CU) to the lower heat exchanger connection and fit the return to the CU.
  3. Add HEC to the drum and heat, maintaining the temperature (max 65°C) throughout the cleaning operation FOR 8-10 hours. If heating is not available, and fit the return to the CU Circulate for 24 hours. When the cleaning is complete, disconnect the lower heat exchanger connection and drain.
  4. Connect a high pressure fresh water supply to the upper heat exchanger connection. Rinse until water runs clear.
  5. Disconnect, drain and dry.
  6.  Can further use of another system cleaning
Keep out of reach of children
Do not store in direct sunlight or heat.
Avoid frost and high temperatures.
Health and Safety
For full Health and Safety data please refer to our specific MSDS Sheet.

                                           Green Life Group  P.B. 12644 Ashdod Israel   77520  www.egreen up.com
                                               Email grnlf01@walla.co.il     Fax 972(0) 88565645 Tel   972(0)88565648


                                                                                         Go Back  Print  Send Page

המפעל טל 088565648 | פקס 088565645  
אושרי קירש  מזכירות      
אבי בירן יצור              0528234169
צבי מדלינסקי             0544286682

            שיווק מגזר חקלאי
       אבי פרציגר   0528099940

            שווק מוסדי ותעשייה      
דני זינגר       0546663480
      שלמה ארגס 0528701029  

לייבסיטי - בניית אתרים